Model :APV601N
Poppet valve is a pneumatically operated valve.
valve is on when pressure is over than 0.30MPa and off by a built-in spring.
When use dispense controller and pressure tank, the shot volume can be controlled to a very small amount
by adjusting the material delivery pressure and the valve opening time. Valve has"suck back effect"
to suck back the material before the valve is off.
APV 6 Series (Air Operated) Poppet Valve
| Valve mode | APV601N | ||
| Valve structure | Poppet valve | ||
| Minimum shot | 0.005 c.c | ||
| Fluid flow (Max.) | 3300 c.c/min | ||
| Viscosity | ~100Pa.s(~100,000cps) | ||
| Wetted parts material | SUS316 | ||
| Diaphragm material | PTFE | ||
| Material inlet(Max.) | 0.69MPa(7.0kgf/cm2) | ||
| Material port dimension | Ø8.5mm, Thread Rc1/8(PT1/8) | ||
| Operating cycle (Max.) | 200 cycles/min. | ||
| Dispensing pressure | 0.30~0.69MPa(3.0~7.0 kgf/cm2) | ||
| Weight | 325g | ||
*Adjust fluid pressure according to viscosity.
*The minimum shot volume depends on the dimension of valve needle.
*Volume(c.c/min):0.1Mpa/min water testing result.
